Safety First
The information provided here is designed for educational use only. You must accept that You and You Alone are Responsible for your safety and safety of others in any endeavor in which you engage. Your safety is your own responsibility, including proper use of equipment and safety gear, and determining whether you have adequate skill and experience. Power tools, electricity, and other resources used in an EV conversion are dangerous, unless used properly and with adequate precautions, including safety gear.
Please visit our Policies page for more information.
Course Content
Lessons
Status
1
Module 1
2
Module 2
3
Module 3
4
Module 4
5
Module 5
6
Module 6
7
Module 7
-
Module 7 Lesson 1 – Maintenance and Troubleshooting
-
Module 7 Lesson 2A – Final Words on OEM Components
-
Module 7 Lesson 2B – DC Conversion Schematic and Display Board
-
Module 7 Lesson 2C – AC Conversion Display Board
-
Module 7 Lesson 3A – How it all goes together – Overview
-
Module 7 Lesson 3 Part 1 – Getting Started, Vehicle Introduction and Prep
-
Module 7 Lesson 3 Part 2 – Installing Components on Component Board and Cables
-
Module 7 Lesson 3 Part 3 – Installing Component Board and 12 volt Wiring
-
Module 7 Lesson 3 Part 4 – Motor Installation
-
Module 7 Lesson 3 Part 5 – Wiring
-
Module 7 Lesson 3 Part 6 – Installing DC/DC Convertor and Heater
-
Module 7 Lesson 3 Part 7 – Installing and wiring the traction pack batteries
-
Module 7 Lesson 3 Part 8 – Charging the traction pack
-
Module 7 Lesson 3 Part 9 – Cooling System and Testing
-
Module 7 Lesson 4 – Final Review and Comments
-
Module 7 Lesson 5 – Additional Resources & Materials
- Module 7 Lesson 1 – Maintenance and Troubleshooting
- Module 7 Lesson 2A – Final Words on OEM Components
- Module 7 Lesson 2B – DC Conversion Schematic and Display Board
- Module 7 Lesson 2C – AC Conversion Display Board
- Module 7 Lesson 3A – How it all goes together – Overview
- Module 7 Lesson 3 Part 1 – Getting Started, Vehicle Introduction and Prep
- Module 7 Lesson 3 Part 2 – Installing Components on Component Board and Cables
- Module 7 Lesson 3 Part 3 – Installing Component Board and 12 volt Wiring
- Module 7 Lesson 3 Part 4 – Motor Installation
- Module 7 Lesson 3 Part 5 – Wiring
- Module 7 Lesson 3 Part 6 – Installing DC/DC Convertor and Heater
- Module 7 Lesson 3 Part 7 – Installing and wiring the traction pack batteries
- Module 7 Lesson 3 Part 8 – Charging the traction pack
- Module 7 Lesson 3 Part 9 – Cooling System and Testing
- Module 7 Lesson 4 – Final Review and Comments
- Module 7 Lesson 5 – Additional Resources & Materials